Industry News

Position:Home > EN > News > Industry News >

What structural features automatic feeder is?

Author: admin Time:2017-10-28
Paper:Mainly by the traction member, carrying member, the first round and the bottom wheel, drive, tensioning devices, chassis and other components. Surrounded by closed traction member on the first round and the end of round, and tensioning devi...

Mainly by the traction member, carrying member, the first round and the bottom wheel, drive, tensioning devices, chassis and other components. Surrounded by closed traction member on the first round and the end of round, and tensioning device tensioning. On the entire length of the traction member, each mounting a certain distance hopper. To prevent the dispersal and dusty material, these moving parts sealed with housing. In operation, an external drive unit head wheel drive traction member and the hopper run. Material from the base of the inlet into the bottom of the base, is moving on to lift the hopper wedges. After reaching the nose, then the role of gravity and centrifugal force of the material from the hopper, the discharge from the discharge port.

Automatic feeder drive adjustment mechanism to adjust seat and trim the base plates, which adjust the seat plate mounted on the punch frame, fine-tune the base plate is attached to the body clip-feeder machine, adjust seat and even a turntable pivot plate pivot on the turntable symmetrical pivoted Timing Pulleys two symmetrically on the turntable and two concentric Timing Pulleys two arc-shaped elongated hole bored through each set a fixed rotary locking bolt the base plate corresponding to the holes drilled, and trimming constituting the seat board also pivotally connected to a pivot turntable, the turntable is pivoted symmetrical two idler, and, on the turntable and symmetrical two idler two concentric arc-shaped elongated hole bored through each set a fixed bolt screwed Lock the base plate corresponding to the holes drilled, the adjustment to fine-tune the composition and configuration of the base plate, on the outside, while the second Timing idler pulley and the two opposing cross capacity at appropriate intervals, and Timing Belt same center line Adjustable Fit the tightness of engagement, so that regulation of the belt feeding device constituted as a result of feed should punch die height adjustment moves fine-tuning, more simple and accurate transmission timing adjustment.

Contact
Contact
We would like to hear your voice

400 phone:13902422981

Tel:0757-86690339

Fax:0757-86690339

Mobile:13902422981
售后服务:13902422981

QQ:214210961

Email:214210961@qq.com

Address:NO.1 Zibianyi Road,Tangkouwo,Shishan Town,Nanhai District,Foshan.

[Up] 
Online service

Online

Online

Online

Tel:
13902422981
WeChat

Official WeChat scan